Tool and Weapon Making

Information on making tool and weapon parts split up into non metal and metal creation

Making non metal parts

 * 1) Check tool station for which parts you need to make the tool/weapon
 * 2) If your have the pattern go to step 5 else get a blank pattern
 * 3) Place Blank Pattern in the Stencil Table and use the Next and Previous Pattern buttons till you find your pattern
 * 4) Remove pattern from right box once you have the one you need.
 * 5) Place pattern in the Part Builder in one of the two far left slots for the left grid
 * 6) Place allowed non metal /*future link*/ material in the slot right of pattern equal or greater than the material cost (Please note that if the part doesn't show up in the right grid just remove and replace the pattern. Shards will be created for material cost of .5 and can be used at a value of .5).
 * 7) Do previous steps for every piece that you need untill you have the pieces need.
 * 8) Place pieces in tool station in appropriate spots on the left side of the arrow and remove new item from the right.
 * 9) Use new item.

Making metal parts
Filler